The Termite Control Can Also Be Done By Statements

DO NOT waste lure by adding it to timbers that do not contain live termites. The colony is killed only if workers take enough of the bait back to the nest. And they will only take it whenever they can harvest it, undisturbed, from inside the damaged lumber you've found. .

Should you find termites in timbers such as the window/door frames, skirting boards inside, or in studs, posts, roof and foundation timbers of any construction, you need to make a small hole into the timber, actually see live termites then insert a light-proof cache of this bait covering the hole in the wood.

See the uneven surface of the window frame. Termites had eaten it out, in some areas leaving only the paint.

Getting My Termite Control Can Also Be Done By To Work

Make an opening into the termites using a pointed knife or fine screwdriver. The gap should be no larger than about 5mm diameter to begin with. (It should be enlarged only when it is time to add the cache of lure ). You can pry into the surface of the timber in which it feels spongy, thin or hollow.

It's only as a last resort you should attempt to open a tunnel on a timber or foundation surface. .

Once you've broken through into where it is hollow, wait for a minute or so. If termites are not there, the soldiers usually come to safeguard the opening while employees repair it. You may see their antennae and their heads blocking the hole. If no live termites appear, leave the hole open and return later or test next day.

Getting My Termite Control Centurion To Work

This reveals how termites will come out of the infested timber into a foil coated mass of lure taped to the surface. Alternatively, if the surface is flat, the feeder may be repaired over the hole and also the termites will enter it to crop the bait.

If the wood has a level surface, then make the hole from corners so that you can line it up with the hole in the bottom of the feeder. In case the access hole into the termites is on a round post or another situation where you cannot repair the feeder to it, you can make a pouch of aluminium foil and duct tape to hold the bait in place.

If you're using the foil method, carefully pull back the edge of the tacky tape to inspect and to replenish the bait. If you are using the feeder system, it is less disturbing if you can add more bait to the original feeder.

The termites you will see as dark brown nests high up in a tree are rarely pests of significance. But the main subterranean termites that do this 99 percent of the $damage we mentioned earlier, will often nest inside the central pipe or even hollowed out center of a mature tree. Mastos, the giant northern termite, dont constantly await the decay of the pipe.

About Termite Control Certificate

(Watch the special box on Mastos).

If at colonising flight period a couple find their way into a hollow tree through maybe a dead/broken-off branch or in through a scar from flame at the bottom , they could not possibly have better conditions. Requires plenty to eat, moisture and protection. A 50 metre travel to your residence would not be out of the question. .

If you have a large eucalypt, peppercorn or a mature fruit tree nearby, you should check it. Use an 15-20mm auger bit long enough to drill into the centre of the trunk at approximately shoulder height. Drill at a slight downward angle and when you are feeling less resistance it'll be because you have reached the pipe.

What Does Termite Control Can Also Be Done By Do?

If not, you can slip in a long thin grass leaf into the drill hole, then leave it for a minute and draw it gradually. Termites may be found holding on, attacking it. If still no live termites are found, return in half an hour or next morning; if there is termite lifetime inside, they will be repairing or have mended the opening using their sand mixture. . click here to find out more

In this situation you dont need to see live termites; its only more satisfying to know you have murdered a colony when you take the next steps

Re-open the drill hole if it has been repairedUsing a funnel, plastic tubing and watering can/bucket, pour at least 20-30 litres of a chlorpyrifos or a bifenthrin solution down into the shrub. These insecticidal concentrations can be purchased by a local hardware shop. They could be known by various brand names but the active ingredients are on the front panel of the tag.